A Quick Guide to Our 480mm 1500W Halogen Lamps
If you’re looking for a way to get things dried or cured fast, these 480mm halogen lamps are a solid bet. We built them to pump out concentrated infrared energy, and because they run at 230V and 1500W, they fit right into most standard setups without needing a total electrical overhaul. They’re basically the perfect “drop-in” fix for mid-sized heating banks. The heat side of things Here’s how they work: we take a tungsten filament, wrap it in quartz, and fill the whole thing with a specific halogen gas mix. Why bother with the gas? It stops the filament from wearing out too quickly. That means we can push the temperature way higher than what you’d find in a regular lightbulb. For you, that means the heat hits almost instantly. No waiting around for things to warm up. What they’re made of We use quartz glass because it doesn’t warp or crack when things get screaming hot. We also reinforced the end-caps. There’s nothing worse than a loose connection because the metal expanded and shifted, so we made sure these stay tight. Most of these use standard R7s bases, so swapping them out is a breeze. Just a heads-up: double-check that your sockets can actually handle 1500W. If they can’t, you’re going to end up with a melted housing, and that’s a mess nobody wants. A few things to watch out for These lamps are powerful. Like, really powerful. If you’re using them for paint curing or PET blowing, you’ve got to get the distance just right. If they’re too close, you’ll scorch your material in seconds. Too far, and you’re wasting energy. It takes a little tinkering to find that sweet spot. And here is the most important part:do not touch the glass with your bare hands. I know it sounds picky, but the oils from your skin leave a residue. That residue creates a hot spot on the quartz, and the lamp will pop way sooner than it should. Grab some gloves, keep the glass clean, and you’re good to go.